Page 1 of 1

need someone with 3d printing exp

PostPosted: 23 Dec 2018 19:05
by Corruptlol
hit me up on teamspeak i need some help on a really basic model.
i ll get it printed with shapeways but i need some help on the design, because i know nothing about creating stuff for 3d printing.

Re: need someone with 3d printing exp

PostPosted: 24 Dec 2018 14:53
by Loui5D
Corruptlol wrote:hit me up on teamspeak i need some help on a really basic model.
i ll get it printed with shapeways but i need some help on the design, because i know nothing about creating stuff for 3d printing.


Send Lee a message, he's done a few bits & pieces.
Masty might have as well for his shop when it was going.

Re: need someone with 3d printing exp

PostPosted: 25 Dec 2018 09:22
by Corruptlol
LEFT is what it looks after i uploaded the .obj on imgr, RIGHT is what it looks in cinema4d ;<


Image

Re: need someone with 3d printing exp

PostPosted: 26 Dec 2018 00:34
by Lee
Have you tried to manipulate your 3D model on sketchup or Tinkercad? Those are the 2 non-pro softs I've used outside of work. They are really optimized for 3D printing.